Solderless Tenninal Connections; Connecting The Speaker Output Tenninals - Pioneer Premier PRS-D2000SPL Owner's Manual

Solderless Terminal Connections
• Since the wire will become loose over time, it
must be periodically inspected and tightened as
necessary.
• Do not solder or bind the ends of the twisted wires.
• Fasten while making sure to not to clamp the
insulating sheath of the wire.
• Use the supplied hexagonal wrench to tighten and
loosen the terminal screw of the amplifier.
Securely fasten the wire with the terminal screw.
However. since excessively tightening the terminal
screw of the System remote control has the risk of
damaging the wire. be careful not to tighten exces-
sively by observing the status of the wire when
tightening.
Connecting the Speaker Output
Terminals
Speaker Wire Size
I. Expose the end of the speaker wires
using nippers or a cutter by about IS
mm to 20 mm (3/4 in.).
'01( •
IX
n1l11 tll .::'(l11l11l
L,/4
in.1
2. Connect the speaker wires to the
speaker output terminals.
• Fix the speaker wires securely with the termi-
nal screws.
Terminal screw
~
..lf
ftl1
):~,~~
less than 6.4 m ks.\ than 10.7
111
less than:! I ft. less than ~5 ft. less than
J
4 ft.
RAWG 6AWG 4AWG
Speaker
output
term inal
3. Put the wire ties in the slits and wrap
the wire ties around the wires.
• Wrap the wire tie around the wire insulatilln.
not the stripped wire.
• Cut off any e:\cess portions of the \\ ire tic".
Wire tie