Connection Diagram - Pioneer Premier PRS-D2000SPL Owner's Manual

C01lnecting the Unit
Connection Diagram
• In the case of connecting the external output from a car stereo to an RCA input, use the jack used for full-
range output. This is because the LPF of the amplifier cannot be turned OFF. If this jack cannot be used,
connect the subwoofer output jack to the RCA input.
Fuse (300 A)
".----U.II--t_.d~'!!!!---
Each amplifier must be SEPA-
\ RATELY fused at 300 A.
Grommet
Battery
....-t:: .....
Ground wire, Terminal (sold sepa-
rately)
~
The ground,wires must be same size
as the battery wire.
Connect to metal body or chassis.
Battery wire (sold separately)
For the wire size, see the
Negative (-) "Connecting the Power Terminal"
terminal section. The battery wire, the
ground wire and the optional direct
ground wire must be same size.
After making all other connections
at the amplifier, connect the bat-
tery wire terminal of the amplifier
to the positive
(+)
terminal of the
battery.
Positive
(+)
terminal
The maximum
length of the wire
between the fuse
and the positive
(+)
terminal of
the battery is 45
cm.
-._=.-
External Output
•
Connecting wire with RCA
pin plugs (sold separately).
.--------....,
Car stereo with
RCA output
jacks
System remote control wire (sold separately)
Connect the male terminal of this wire to the system remote
control terminal of the car stereo (SYSTEM REMOTE CONTROL). The
female terminal can be connected to the auto-antenna relay control terminal.
If the car stereo does not have a system remote control terminal, connect the
male terminal to the power terminal through the ignition switch.
Jack for the bass boost remote control
Connect this jack and the bass boost remote
control with the bass boost remote control wire.
Bass Boost Remote
Control Wire
Fuse (40 A)
SYNC OUTPUT/SYNC INPUT jack
See the "Connecting the Speaker Wires"
section for SYNC OUTPUT/SYNC
INPUT jack connection instructions.
Bass Boost Remo/control 6 m
4::::~~~~~~I:~~~iR~A
input
ja~k
~~9ft.8in) ~g~-j1fa
~ ~::::=t:.:.::::.=::::...;r ~. · -- ~I_@):::°=::l:=~
/
Speaker output terminal
See the "Connecting the
~
Reverse side Speaker Wires" section
H~===========I:::::::
=-
for speaker connection
- _ ..._ ] $\ \
instructions.
cm"'~'c:J
H. .
~-
J
~ ~FUSe(40A)