Connections When Using The Speaker Input Wire; Solderless Terminal Connections - Pioneer GM-ME600X6 Owner's Manual

Speaker setting and power output
SPEAKER SETTING
2
NOR
4
2
HIGH
4
Connections when using the
speaker input wire
Connect the headunit speaker output wires to
the amplifier using the supplied speaker input
wire with RCA pin cord.
Make sure to switch the INPUT SENS switch
to SP.
1 Headunit
2 Speaker output
3 Red: Right
4 Black: Right
5 Black: Left
6 White: Left
7 Speaker input wire with RCA pin cord
to the RCA input jack of this unit
Notes
If speaker input wires from a headunit are
connected to this amplifier, the amplifier will
automatically turn on when the headunit is
turned on. When the headunit is turned off,
the amplifier turns off automatically. This
function may not work with some headunits.
In such cases, make sure that the front chan-
nel is connected correctly. If the function still
does not work, please use a system remote
control wire (sold separately). If multiple
amplifiers are to be connected together
synchronously, connect the headunit and all
amplifiers via the system remote control wire.
MONO 2CH
- 100 W
150 W 75 W
- 100 W
200 W 100 W
En
Solderless terminal
connections
Since the wire may become loose over time,
it must be periodically inspected and tight-
ened as necessary.
Do not solder or bind the ends of the
twisted wires.
Fasten while making sure to not to clamp
the insulating sheath of the wire.
Use the supplied hexagonal wrench to
tighten and loosen the terminal screw of the
amplifier and use it to securely fasten the
wire. Be careful to avoid excessive tighten-
ing of this screw, which may damage the
wire.
Connecting the power terminal
WARNING
If the battery wire is not securely fixed to the
terminal using the terminal screws, there is
a risk of overheating, malfunction and injury,
including burns.
Always use the recommended bat-
tery and ground wire, sold separately.
Connect the battery wire directly to the
boat battery positive ( ) terminal and the
ground wire to the boat body.
Recommended wires size (AWG: American
Wire Gauge) is as follows. The battery wire,
the ground wire and the optional direct
ground wire must be same size.
Use a wire of 12 AWG to 16 AWG wire for
the speaker wire.
When drilling a cable pass-thru into a bulk-
head or barrier wall, route the cable through
carefully and seal the hole to prevent fumes
from seeping from engine compartment to
other areas.
compartment to the boat interior.
After completing all other amplifier con-
nections, finally connect the battery wire
terminal of the amplifier to the positive
battery terminal.
2
1 3