Table of Contents
Advertisement
UX-A1000U
[4] Error code table
1. Communication error code table
G3 Transmission
Code
Final received signal
0
Incomplete signal frame
1
NSF, DIS
2
CFR
3
FTT
4
MCF
5
PIP or PIN
6
RTN or RTP
7
No signal or DCN
8
11
12
13
G3 Reception
Code
Final received signal
0
Incomplete signal frame
1
NSS, DCS
2
NSC, DTC
3
EOP
4
EOM
5
MPS
6
PR1-Q
7
No signal or DCN
8
9
10
11
12
13
Cannot recognize bit stream after flag
Cannot recognize DCS signal by echo etc.
Cannot recognize NSS signal (FIF code etc)
Disconnects line during reception (carrier missing etc)
Disconnects line by fall back
Disconnects line during reception of multi page
Cannot recognize NSS, DCS signal in the case of mode change
The line is hung up without replying to telephone request from the receiving party.
Cannot recognize NSS, DCS signal after transmit RTN or RTP signal.
No response in receiver side or DCN signal received* (transmitter side)
−
Owing to error in some page the error could not be corrected although the specified number of
error retransmissions were attempted.
−
Error occurred after or while reception by the remote (receiving) machine was revealed to be
impossible.
−
Error occurred just after fallback.
−
Error occurred after a response to retransmission end command was received.
Cannot recognize bit stream after flag
Cannot recognize CFR or FTT signal
Disconnects line during transmission (line error)
Cannot recognize NSS signal (FIF code etc)
Cannot recognize MCF, PIP, PIN, RTN, RTP signal
Cannot recognize MCF, PIP, PIN, RTN, RTP signal in the case of mode change
The line is hung up without replying to communication request.
Cannot recognize PIP, PIN signal in the case of TALK request
No response in transmitter (cannot recognize DIS signal) or DCN signal received* (receiver side)
−
Error occurred upon completion of reception of all pages.
−
Error occurred when mode was changed or Transmission/Reception switching was performed.
−
Error occurred during partial page or physical page reception.
−
Error occurred after or during inquiry from the remote (transmitting) machine as to whether
reception is possible or not.
−
Error occurred during or just after fallback.
−
Error occurred after the retransmission end command was received.
Error Condition (Receiver side)
Error Condition (Receiver side)
2 – 26
2 – 26
Advertisement
Table of Contents
