Figure 12. Available Devices Area - Princeton PIXIS-XB System User Manual

34
Getting Started
1.
2. Power ON the camera (the power switch is on the power supply).
3. Turn on the computer power and start the LightField application software.
Setting the Parameters
Note: The following procedure is based on LightField. Basic familiarity with the
LightField software is assumed. If this is not the case, you may want to review the
software manual or have it available while performing this procedure.
1. After LightField opens, you should see an icon representing your camera in the
2. Drag the icon into the Experiment Devices area.
PIXIS-XB System Manual
If the system is liquid-cooled, double-check that the CoolCUBE
50:50 mixture of ethylene glycol and water and that the hose connections are
secure. Refer to "Making the Camera-Circulator Connections for a
CoolCUBEII" on page 25 for setup information. When satisfied that these
requirements are met, do the following.
a. Turn on the CoolCUBE
through the camera..
b. Inspect the coolant hose connections to be sure there are no leaks.
Available Devices area. In the figure above, the camera is a PIXIS-XB:1024BR.
. It will power up and begin pumping coolant
II

Figure 12. Available Devices Area

Version 2
is filled with a
II