Chapter 4
LightField
The following installation is performed via the LightField software installation CD.
1. Before starting the installation:
2. Insert the CD and follow the installation wizard prompts.
3. After the installation finishes, reboot the computer.
4. Connect the PIXIS system components to your computer and power them on.
5. Start LightField, activate it, and begin setting up your experiment.
Verify that the computer operating system is Windows Vista (64-bit) or
Windows 7 (64-bit).
Confirm that your computer supports USB 2.0. If it does not, please refer to
the manufacturer's instructions for installing a USB 2.0 interface card.
If a hard key was supplied with the software, internet connectivity is not
required. For earlier software releases, Internet connection was usually
required for product activation.
Figure 5. LightField Installation Wizard dialog
System Setup
23
23