Chapter 3 Initial System Verification - Princeton PIXIS-XB System User Manual

Initial System Verification
The list and diagrams below briefly describe the sequence of actions required
to install your system and verify operation. Refer to the indicated references
for more detailed information.
1. If the system components have not already been unpacked, unpack
them and inspect their carton(s) and the system components for
in-transit damage.
2. Verify that all system components have been received.
3. If the components show no signs of damage, verify that the
appropriate power cord has been supplied with the power supply.
4. If the application software is not already installed in the host
computer, install it.
5. If the USB2 interface card is not already installed in the host
computer, install it. Follow the manufacturer's instructions
6. With the power supply disconnected from the camera, connect the USB
cable to the USB port at the rear of the camera and to the USB port at
the computer.
7. Air-Cooled System: Plug the power supply into the rear of the
camera and plug the power supply into the power source.
Liquid-Cooled System: Plug the power supply into the rear of the
camera and plug the power supply into the power source. Make the
hose connections to the camera. Plug the circulator into the power
source. Add coolant if necessary. Turn on the circulator.
8. Turn the camera ON.
9. Turn on the computer and begin running the application software.
10. Enter the hardware setup information or load the defaults from the
camera.
11. When the system reaches temperature lock, begin acquiring data in
focus mode.
12. After verifying that the camera sees, turn the camera supply OFF. If
there is a circulator attached and running, turn it off as well.
Action
Chapter 3
Reference
Chapter 4 System Setup,
page 19
Chapter 4 System Setup,
page 20
Chapter 4 System Setup,
page 20
Chapter 4 System Setup,
page 22 & Software manual
Manufacturer's instructions
Chapter 4 System Setup,
page 24
Software manual
Chapter 5 Operation,
page 26
Chapter 5 Operation,
page 32 or page 35
17