24
Mounting the Camera
On the bottom of the camera near the front is a threaded hole (1/4"-20 tap,0.25" deep)
that can be used to mount the camera. A ¼-20 to M6x0.8 thread adapter is also supplied.
Figure 6 shows the location of the hole. The distance of the hole from the front of the
camera is either 1.00" [25.4 mm] or 1.55" [39.2 mm].
Princeton Instruments does not supply a vacuum interface flange but has provided a
dimensioned drawing with the minimum design requirements for a customer-supplied
flange (see page 83, of Appendix B).
PIXIS-XB System Manual
Figure 6. Position of Camera Mounting Hole
Version 2