Carrier Infinity ICS 58MVC 100 Series Installation Instructions Manual page 9

/_ _TERNATE DRAIN
TUBE LOCATION
CONDENSATE TRAP --
DRAIN TUBE LOCATION
m BLOWER SHELF &-- FURNACE
\
DOOR
FIELD ,..._
DRAIN
CONN
UPFLOW APPLICATIONS
f_ CONDENSATE
/ TRA;uRNACE -7
j SIDe,,,"
,:_3 ......
_'/ /I 47/8(124mm)
21 J
l iie
261/4 /2
(667mm) (38mm)
SIDE VIEW FRONT VIEW
DOWNFLOW AND ALTERNATE
EXTERNAL UPFLOW APPLICATIONS
FURNACE
DOOR
4
(102mm)
%2972 /4
FIELD (667mm)
DRAIN
CONN
END VIEW
FURNACE
SIDE
!
4(146mm)
(102ram'
3/4
(19ram)
FRONT Vl EW
HORIZONTAL
APPLICATIONS
SLOT FOR SCREW --j
HORIZONTAL /
APPLICATION
(OPTIONAL) /
11/2 (88mm)]
Uq --- ;
GUIDES -- _1 ,!
(WHEN USED)
(57mm)
FRONT VIEW SIDE VIEW
1/40D
COLLECTOR BOX TO
TRAP RELIEF PORT
1/20D
INDUCER HOUSING
DRAIN CONNECTION
5/80D
COLLECTOR BOX
DRAIN CONNECTION
SCREW HOLE FOR
UPFLOW OR DOWN-
FLOW APPLICATIONS
(OPTIONAL)
1/2 IN. PVC OR CPVC
Fig. 6 - Condensate Trap
A07459
NOTE: Failure to use CPVC elbows may allow drain to kink,
preventing draining.
k. Connect larger diameter drain tube and clamp (factory-
supplied in loose parts bag) to condensate trap and clamp
securely.
1. Route tube to coupling and cut to appropriate length.
m. Attach tube to coupling and clamp securely.
Condensate Trap (Alternate Upflow Orientation)
An alternate location for the condensate trap is the left-hand side
of casing. (See Fig. 2 and 8.)
NOTE: If the alternate left-hand side of casing location is used,
the factory-connected drain and relief port tubes must be
disconnected and modified for attachment. See Condensate Trap
Tubing (Alternate Upflow Orientation) section for tubing
attachment.
To relocate condensate trap to the left-hand side, perform the
following:
1. Remove three tubes connected to condensate trap.
2. Remove trap from blower shelf by gently pushing tabs in-
ward and rotating trap.
3. Install casing hole filler cap (factory-supplied in loose
parts bag) into blower shelf hole where trap was removed.
CARBON MONOXIDE POISONING HAZARD
Failure to follow this warning could result in personal
iniury or death.
Casing hole filler cap must be installed in blower shelf
hole when condensate trap is relocated to prevent
combustion products being drawn in from appliances in
the equipment room.
4. Install condensate trap into left-hand casing hole by in-
serting tube connection stubs through casing hole and ro-
tating until tabs snap into locking position.
5. Fill unused condensate trap casing holes with plastic filler
caps (factory-supplied in loose parts bag).
Condensate Trap 3klbing (Alternate Uptlow Orientation)
NOTE: See Fig. 8 or tube routing label on main furnace door to
confirm location of these tubes.