junger D-AP LM4 Manual page 15

D*AP LM 4
Authentication
Enable
Change Password for
Password
Repeat
Important Note! The authentication may be enabled / disabled form the console interface as well
(see page 8 "1: Manage Password") via USB connection but also via Telnet! If you have higher security
demands you should turn the Telnet server off. Authentication will turned off and passwords will be reset if
one initializes the device to factory default (see Reboot - page 19, INIT/RESET rear button - page 4).
If there was an authentication failure, the admin
will be notified on next proper login about such conditions :
The pop up appears as often as an login failed.
Network IP address setup, see above: "Getting started – IP setup of the device via web browser"
IP Address
Netmask
Gateway
Transmit Metering Data
Enable
UDP Port Range Start
UDP Port Range End
Service Options
Maintenance Interface
via RPC
Telnet Server
Diagnostics
get diagnostics file
to prevent non authorized people from changing device settings the
administrator may assign passwords for either the admin and/or an
operator (same applies for talent/artist). While the admin is allowed to set
everything, an operator is just allowed to load presets. Parameters will be
reset if there was an attempt from the operator to change it.
[enable / disable]
the administrator may turn authentication off.
[admin / operator]
Select which password you will set / change
key in a password
Default passwords are: admin (for admin) and operate (for operator).
repeat that password
metering data will be streamed via UDP protocol. In order to receive such
data by external applications you must define ports (port range) for
matching fire wall definitions.
streaming of metering data via UDP on demand of an external application
rd
(web browser, J*AM, 3
lowest port number.
highest port number.
an external application, that can not be configured prior to start up like the
web GUI will ask the LM 4 for the possible port range and will start looking
if the first port is available on the PC where the application resides. If yes it
will tell the LM 4 to start streaming on that port.
If not the application must look for next available port.
Other applications like the J*AM which have pre definitions will not ask the
LM 4 for possible UDP port range. They will use the one from the
application set up menu.
for in house use to enable communication with factory tools.
enables a telnet server to connect the consol interface via IP (port 21).
pressing this soft button will start the assembly of a diagnostics file.
The file will be presented in XML format for download.
If you experience unexpected behavior of the device you may be asked by
the Junger service team to send such file by e-mail for analysis.
11
party).