Table of Contents
Advertisement
On/Off switch
outlets when switched on. It also acts as a manual reset for overload,
low battery voltage, and over-temperature fault conditions. The inverter
can be reset by turning the switch off for five seconds, then on again.
The green power light indicates AC power is present at the
Power light
outlet and the PROwatt 150 is operating normally.
The red fault light indicates the inverter has shutdown
Fault light
because of low or high battery voltage, AC overload or excessively high
temperatures.
Connecting the PROwatt 150
Location
For the best performance results place the inverter in a location that is:
•
Dry — do not expose the unit to water drip or spray.
•
Cool — operate the unit in ambient temperatures between 32° F
(0° C) and 100° F (40° C). Keep it away from heating vents.
•
Well ventilated — allow at least two inches (5 cm) of clearance
around the unit for proper cooling.
Connecting
Follow these steps to install the unit:
1.
Place the unit in a flat dry location such as the dashboard of your
vehicle. Use the floor only if it is dry and free of any debris which
could get into the inverter.
8
The On/Off switch enables output AC power at the AC
Advertisement
Table of Contents
