Connecting The Xpower 175 Plus And Xpower 400 Plus For Loads Under 150 Watts - Xantrex XPower 175 Plus Owner's Manual

Connecting the XPower 175 Plus and XPower 400
Plus for Loads Under 150 Watts
Follow these steps to connect the XPower 175 Plus or XPower 400 Plus
inverter:
1. Place the inverter on a flat surface like the floor of your vehicle.
2. Make sure the On/Off switch on the front panel is off.
3. The XPower 175 Plus has a power cord with lighter plug hard-
wired into it, so you do not need to complete this step.
If you have a XPower 400 Plus, take the power cord equipped with
the lighter plug
cabling terminals on the back of the inverter. (The cabling terminals
are shown in
CAUTION
Make sure you connect red to red and black to black, and make sure
you screw the nuts on tightly.
4. Place the inverter's lighter plug in the vehicle's cigarette lighter
socket or a 12 volt outlet.
16
(Figure 5) and place the ring terminals over the two
Figure 4.))