Replacement Of Batteries - Toyotomi TAG-A16 HDI Service Manual

About switch between Fahrenheit and Centigrade
Under status of unit off, press MODE and - buttons simultaneously to switch
Combination of " TEMP" and "CLOCK" buttons : About Energy-saving Function
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.Nixie tube on the remote controller
displays "SE". Repeat the operation to quit the function.
Combination of " TEMP" and "CLOCK" buttons : About 8
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start 8
displays " " and a selected temperature of "8 " (46 if Fahrenheit is adopted). Repeat the operation to quit the function.
About Quiet function
If Auto Quiet mode has been selected, after the room temperature reached the setting temperature or 10mins later, the AC will
immediately enter into the Quiet running status, at this time the fan speed is not adjustable.
About Sleep function
Under the Fan and Auto mode, the Sleep function cannot be set up, under Dehumidify mode, only Sleep 1 can be selected.
Select and enter into any kind of Sleep mode, the Quiet function will be attached and stared, different Quiet status could be
optional and turned off.
1.Slightly to press the place with
cover of wireless remote control.(As show in Fig 1. )
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
(As show in Fig 2.)
4. Attach the back cover of wireless remote control.
NOTE:
●
When changing the batteries, do not use the old or different batteries, otherwise,
it can cause the malfunction of the wireless remote control.
●
If the wireless remote control will not be used for along time, please take them out,
and don't let the leakage liquid damage the wireless remote control.
●
The operation should be in its receiving range.
●
It should be placed where is 1m away from the TV set or stereo sound sets.
●
If the remote control cannot operate normally, please take the batteries out, and
then reinsert it 30s later; if it is also abnormal ,please replace the batteries.
●
If the main unit needs to be remote controlled, please aim remote controller at the
receiver of main unit in order to improve the receiving sensitivity of the main unit.
●
When the remote controller sends out signal, a mark
The bell will ring if the main unit receives effective signal.
, along the arrowhead direction to push the back
will flicker for about 1s.
º C and ºF .
Heating Function
Heating Function.Nixie tube on the remote controller
Fig.1
2
1
Fig.2
3
4
Sketch map for
changing batteries