Replacement Of Batteries In Remote Controller - Toyotomi TKN-2328R32 User Manual

temperature display will resume to original setting temperature.
• Sleep 3 the sleep curve setting under Sleep mode by DIY could be
inquired:
The user could accord to sleep curve setting method to inquire the
presetting sleep curve, enter into user individuation sleep setting
status, but do not change the temperature, press "Health" button
directly for confirmation. Note: In the above presetting or enquiry
procedure, if continuously within 10s, there is no button pressed,
the sleep curve setting within 10s, there is no button pressed, the
sleep curve setting status will be automatically quit and resume
to display the original displaying. In the presetting or enquiry
procedure, press " On/Off " button, "Mode" button, "Clock" and
"Light" buttons simultaneously, the sleep curve setting or enquiry
status will quit similarly.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked with "
shown in the fig, and then push out the cover of battery box along
the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position
of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
NOTICE
• During operation, point the remote control signal sender at the
receiving window on indoor unit.
• The distance between signal sender and receiving window should
be no more than 8m, and there should be no obstacles between
them.
• Signal may be interfered easily in the room where there is
fluorescent lamp or wireless telephone; remote controller should
be close to indoor unit during operation.
reinstall battery
remove
Cover of battery box
22
", as
GB