Toyotomi TAG-A16 HDI Service Manual page 20

SLEEP
SLEEP BUTTON
(3) Under the initial presetting temperature 21
function started up, the temperature will decrease 1
after 2 decreased, this temperature will be maintained.
(4) Under the initial presetting temperature 28
Sleep function started up, the temperature will decrease 1
every hour, after 3 decreased, this temperature will be maintained.
Sleep 3- the sleep curve setting under Sleep mode by DIY:
●
(1) Under Sleep 3 mode, press "Turbo" button for a long time, remote
control enters into user individuation sleep setting status, at this
time, the time of remote control will display "1hour ", the setting
temperature "88" will display the corresponding temperature of last
setting sleep curve and blink (The first entering will display
according to the initial curve setting value of original factory);
+
(2) Adjust " " and "
setting temperature, after adjusted, press "Trubo "button for
confirmation;
(3) At this time, 1hour will be automatically increased at the timer
postion on the remote control, (that are "2hours" or "3hours "
or "8hours "), the place of setting temperature "88" will
display the corresponding temperature of last setting sleep curve
and blink;
(4) Repeat the above step (2 )
temperature setting finished, sleep curve setting finished, at this
time, the remote control will resume the original timer display;
temperature display will resume to original setting temperature.
Sleep3- the sleep curve setting under Sleep mode by DIY could
●
be inquired:
The user could accord to sleep curve setting method to inquire
the presetting sleep curve, enter into user individuation sleep
setting status, but do not change the temperature, press "Turbo"
button directly for confirmation.
Note: In the above presetting or enquiry procedure, if continuously
within10s, there is no button pressed, the sleep curve setting
status will be automatically quit and resume to display the original
displaying. In the presetting or enquiry procedure, press "ON/OFF"
button, "Mode" button, "Timer"button or "Sleep" button, the sleep
curve setting or enquiry status will quit similarly.
27 , after Sleep
in every hour,
" button, could change the corresponding
(3) operation, until 8hours
30 , after
in