Function Introduction For Combination Buttons; Replacement Of Batteries In Remote Controller - Toyotomi HTN/HTG20-09R32 User Manual

Introduction for buttons on remote controller
12
Light button
Press this button to
off the display's
light.

Function introduction for combination buttons

Combination of " " and " " buttons: About lock
Press " " and "
controller is locked,
three times.
Combination of "MODE" and " " buttons:
About switch between Fahrenheit and centigrade
At unit OFF, press "MODE" and "
Combination of "TEMP" and "TIMER" buttons:
About Energy-saving Function
Press "TEMP" and "TIMER" simultaneously in COOL mode to start e nergy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
Combination of "TEMP" and "TIMER" buttons:
About 8 Heating Function (Not available)
Press "TEMP" and "TIMER" simultaneously in HEAT mode to start 8
Nixie tube on the remote controller displays "
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
turn on the display's light and press this button again to turn
" buttons simultaneously 3s to lock or unlock the keypad. If the remote
is displayed. In this case, pressing any button,
" buttons simultaneously to switch between
" and a selected temperature of "8 ".
signal sender
15
blinks
Heating Function
battery
reinstall
remove
Cover of battery box
and .
GB