Interactive Status - Motorola DCH70 Installation Manual

4 DIAGNOSTICS

Interactive Status

This diagnostic tool gathers data about your system.
The Interactive Status fields are:
Field
IP
UPM
Upstream ID
Downstream
ID
State
Description
The set-top IP address assigned by the NC 1500, in dotted-decimal format; for example
xxx.xxx.xxx.xxx where each xxx ranges from 000 to 255. 0.0.0.0 is displayed if the IP
address is not configured or unknown.
The upstream modem address. This UPM value is the same as the terminal ID assigned by
the DAC 6000. It is a unique, system-generated, eight-digit integer between 1 and
16777215. 00000000 is displayed when the UPM is not configured or unknown.
The set-top transmission parameter assigned by the DAC 6000. It is a four-digit decimal
value from 0000 to 9999. 0000 is displayed if the Upstream ID is not configured or
unknown.
The set-top transmission parameter assigned by the DAC 6000. It is a four-digit decimal
value from 0000 to 9999. 0000 is displayed if the Downstream ID is not configured or
unknown.
The interactive status of the set-top:
OSD
UNCONFIG
MAC_CONNECT
INIT_WAIT_DC_OR_C
WAIT_LM_ACK
Description
The set-top is not configured for the interactive system, and
the platform should run as pre-interactive.
The set-top is waiting to establish a connection to the MAC
PID Stream.
The set-top is in the interactive initialization state and waiting
for the default configuration or the contention channel list
messages.
The set-top is in the interactive initialization state and waiting
for Link Management Response ACK for Local Address
Message.
32