Motorola DCH70 Installation Manual page 47

Cable receiver
Hide thumbs Also See for DCH70:
Table of Contents

Advertisement

4 DIAGNOSTICS
Field
Connected
Home Table
Connected
Home Link
Status Table
Collecting
Data
Description
The Connected Home Table contains information related to each device connected to the
set-top through the Home Network. The fields included in the Connected Home Table are:
Nodes
The MoCA Node ID and Set-top MR-DVR Node ID values of each
device in the Home Network in format MM/SS, where MM equals the
decimal digit MoCA Node ID within the range of 0-15 and SS equals the
decimal digit Set-top MR-DVR Node ID within the range 1-8. Displays a
single dash "-" for the device if this information is not available.
Displays an asterisk "*" in the row of the device that is the Local
Device displaying diagnostics
Displays an "N" in the row for the device that is the Network
Coordinator for the Home Network. Displays an "M" in the row of the
device that is the MR-DVR Set-top Master device.
Displays "da" in the row of any device that is in the Home Network but
is de-authorized for MR-DVR services
Displays "inact" in the row of any device that is inactive in the MR-DVR
network
Dev
Displays the device type of the device:listed:
NIM
EHub
ETerm Hub
Term
N/A
#Ses
The total number of MR-DVR playback and record sessions currently being
supported by the device listed
Ver
Displays the software version of the Entropic chipset in xx.yy format of the
device listed
Mac
The MAC address of the device listed in 8-byte colon-hex format
(xx:xx:xx:xx:xx:xx:xx:xx)
IP
The IP address of the device listed in 4-byte dotted decimal format
(xxx.xxx.xxx.xxx). Displays "0.0.0.0" if the IP address of the device is not
configured or unknown.
The Connected Home Link Status Table contains information related to the transmit phy
rate between each device in the Home Network and may display warning indications under
fault conditions. The warning status fields are in format "aabbcc" preceding the "From
Node" row heading. These fields are blank if no fault condition exists, or display the
following under the defined conditions:
aa
Displays "Bw" in the "aa" portion to indicate a minimum bandwidth available
warning
bb
Displays "Fr" in the "bb" portion to indicate a packet error warning
cc
Displays "Pw" in the "cc" portion to indicate a power level warning
Displays "In Progress" when the set-top is in the process of collecting the required
data and populating the Connected Home Link Status Table
Displays "Complete" when the set-top has completed collecting the required data
and has populated the Connected Home Link Status Table
Displays "N/A" when the data it has collected is invalid or unable to retrieve the
data
39

Advertisement

Table of Contents
loading

Table of Contents