Agile Oob Tuner Hunting; Summary Of Operator Selection Of The Oob Frequency (Osd Frequency Override In Hunted Mode) - Motorola DCH70 Installation Manual

4 DIAGNOSTICS
Field Description
Hunt The state of OOB stream acquisition
Mode
OSD
None
RR (Round
Robin)
EMM
FIX
SRCH
Cur Freq The current out-of-band frequency
LKC The last known carrier (OOB frequency that had correct Provider ID)
EMM The ID of the provider of the Entitlement Management Message (EMM)
Provider
ID

Agile OOB Tuner Hunting

Manual control for selecting an OOB frequency can be made while in the OOB
Status diagnostics screen by pressing the
Menu button a second time, or press the
If the set-top is in the process of hunting for an OOB frequency, control of frequency
selection is suspended, i.e. pressing Menu button on OOB status screen to display
MANUAL FREQ is not available when the set-top is hunting.

Summary of Operator Selection of the OOB Frequency (OSD Frequency Override in Hunted Mode)

The manual override frequency capability is only displayed if the box is not currently
hunting and the operator presses the MENU key while OOB OSD diagnostics are
displayed. The MANUAL FREQ displays the LKC and allows the operator to select
(vial scroll up/down) a specific frequency to check if a valid OOB is on that specific
frequency. The MANUAL FREQ parameter is the OOB frequency selected in the
frequency selection mode and displayed in MHz, with the specific values of 75.25,
104.20, 72.75, 92.25, 98.25, 107 .25, 107 .40, 110.25, 116.25, and 103.75.
1. When in the OOB Receiver Status Diagnostic, press the MENU button to enter
the frequency selection mode. The OSD displays a new "MANUAL FREQ" line at
the bottom of the screen, which indicates the last known carrier frequency. At
this point, if desired, the operator can exit the frequency change mode by
pressing the MENU key a second time.
2. The operator can use the UP/DOWN channel or cursor keys to scroll through all
10 frequencies until the desired new OOB frequency is found. The new
frequency selections will appear on the "MANUAL FREQ" line of the OSD.
Description
The set-top is locked to an OOB carrier
The set-top is searching OOB frequencies trying to find an EMM Provider of
0 or 1.
The set-top received a Provider ID change and is searching OOB frequencies
for a new ID.
The set-top has been commanded to attempt to lock onto a frequency.
The set-top at some point had a valid Provider ID on the OOB frequency and
is attempting to re-acquire it.
MENU
POWER
17
button. To exit this mode, press the
button.