Set Specific Environment Of Each Terminal - Casio V-N500 Series Quick Start Manual

(7) Start up the Copy Devices tool on the master units (replication source).
(8) Select 2. Sender mode of the Copy Devices tool on the master units (replication source).
(9) Start up the Settings tool on the slave unit (replication destination), and enable WiFi-Direct in the
More... menu.
(10) Start up the Copy Devices tool on the slave unit (replication destination).
(11) Select 1. Receiver mode of the Copy Devices tool on the slave unit (replication destination).
Repeat Steps (9), (10) and (11) for all slave units (replication destinations).
(12) Select Start of the Copy Devices tool on the slave unit (replication destination).
In the first attempt, make sure to select Start of the Copy Devices tool on the slave unit (replication
destination) before selecting Start of the Copy Devices tool on the master unit (replication source).
When Start is selected and replication starts, the background color of the Copy Devices tool on
slave units (replication destination) becomes green.
(13) Select Start of the Copy Devices tool on the master unit (replication source).
When Start is selected and replication starts, the background color of the Copy Devices tool on the
master units (replication source) becomes blue.
Repeat Step (12) for all slave units (replication destinations).
It's possible to add slave unit (replication destination) during replication.
(14) Execute restore of the backup data on the slave unit (replication destination), and restart it.
When it's completed to transfer the backup data to the slave unit (replication destination), the
background color of the Copy Devices tool on the slave unit (replication destination) becomes
orange.
Then, the dialog to inform the completion of receipt and ask to execute restore and reset is appeared.
Select Yes in this dialog.
(15) Finish the Copy Devices tool on the master units of the master unit (replication source).
When replication of the environment on the prepared slave units (replication destinations) is completed,
select Finish in the Copy Devices tool on the master unit, and finish the Copy Devices tool on
the master unit.
The replication of the environment to other terminals is completed.
■ Precautions
If there is any other device that is the group owner of WiFi-Direct nearby, the slave unit (replication
destination) recognizes it as the master unit (replication source), and does not operate correctly.
When using the Copy Devices tool, confirm there is no such device nearby before use.

8.1.6 Set Specific Environment of Each Terminal

When configuration of the terminal common environment is finished, perform each terminal-specific
environment.
66