Table of Contents
Advertisement
Chapter 4: Operation
Power
The touchmonitor ships in an ON state.
To turn the touchmonitor on or off, press the touchmonitor power button on the OSD controller
once.
The Power Status LED on the OSD controller functions according to the following table:
The system consumes low power when in SLEEP and OFF modes. For detailed power
consumption specifications, refer to technical specifications on the Elo website
http://www.elotouch.com
Touching the screen will bring the attached host PC out of SLEEP mode (similar to moving the
mouse or pressing a keyboard key).
To improve reliability and reduce wasteful power consumption, disconnect the AC power cable
from the monitor when long periods of disuse are planned.
Touch
Your touchmonitor is factory-calibrated and should not need manual calibration (unless the
input video is not fully scaled to the native resolution, or the touch experience needs to be
calibrated to a specific user).
iTouch Plus Touchscreen Technology
When connected to Windows 7 computers, the touchmonitor can report two simultaneous
touches. The iTouch Plus touchscreen can be re-calibrated to your displayed video image, if
needed, through the Calibration function in the Elo driver control panel.
The iTouch Plus driver will only support multiple monitor if they are all using the iTouch Plus
Touchmonitor status
OFF
SLEEP
ON
LED status
OFF
PULSING
ON
User Manual: 1930L/1931L
SW602163 Rev A, Page 15 of 33
Advertisement
Table of Contents
