Program 9903 Allows Atru Pcb In Slot 1; Speed Dial; 4-Digit System Speed Dial Bin Displays Wrong Name; Pressing Super Display Soft Key When No Block Assigned Resets System - NEC DS2000 Release Notes

DS2000 03.20.07 Release Notes
Software Corrections in 03.20.07

Program 9903 Allows ATRU PCB In Slot 1

Speed Dial

4-Digit System Speed Dial Bin Displays Wrong Name

Pressing Super Display Soft Key When No Block Assigned Resets System

Station Message Detail Recording

Abbreviated Caller ID Status Messages

T1 Trunking

Out Of Frame Sync Recovery Improved

30 ◆ 03.20.07
In prior versions of 03.**.** software, the system would auto-ID an ATRU PCB plugged into slot
1, even though slot 1 is reserved for a 16DSTU PCB. In addition, program 9903-Set Up Trunks
would recognize the installed PCB. In software version 03.20.07, an ATRU PCB plugged into slot 1
is ignored by the system, will not auto-ID, and will not be recognized by program 9903.
Software version 03.20.07 corrects a problem with 4-digit System Speed Dial numbers in prior
03.**.** versions in which names would be assigned to the wrong bins in 1101-System Speed Dial
Numbers.
In prior software versions, if a Super Display Telephone user pressed SP DIAL 1 or SP DIAL 2 and
their extension had no Speed Dial block assigned in 1802-Speed Dial Block, the system would
reset. This is corrected in software version 03.20.07.
Software version 03.20.07 corrects the following Caller ID Status Messages on the SMDR report:
Prior 03.**.** Versions
Priv
Out
Software version 03.20.07 incorporates enhancements that improves the ability of the T1 PCB to
recover from an Out of Frame Sync condition.
03.20.07
Private Number
Out of Area Number
DS2000 Release Notes