Calculating The Battery Size; 1: Nfpa Battery Requirements; 2: Selecting And Locating Batteries - Fire-Lite Alarms MRP-2001E Installation, Operation, And Programming Manual

Power Supply Calculations
5.4
Use Table 5-4 to calculate the total Standby and Alarm load in ampere hours (AH). This total load
determines the battery size (in AH), required to support the control panel under the loss of AC
power. Complete Table 5-4 as follows:
1. Enter the totals from Table 5-3 on page 101, Calculation Columns 2 and 3 where shown
2. Enter the NFPA Standby and Alarm times (refer to 'NFPA Requirements' below)
3. Calculate the ampere hours for Standby and Alarm, then sum the Standby and Alarm
ampere hours
4. Multiply the sum by the derating factor of 1.2 to calculate the proper battery size (in AH)
5. Write the ampere hour requirements on the Protected Premises label located inside the cabi-
net door
TABLE 5-4:Total Secondary Power Requirements at 24 VDC
Secondary Standby Load
(total from Table 5-3 Calculation
Column 3)
[ ]
Primary Alarm Load
(total from Table 5-3 Calculation
Column 2)
[ ]
Sum of Standby and Alarm Ampere Hours
Multiply by the Derating Factor
Battery Size, Total Ampere Hours Required
5.4.1 NFPA Battery Requirements
NFPA 72 Local, Central and Proprietary Fire Alarm Systems require 24 hours of standby power
followed by 5 minutes in alarm
5.4.2 Selecting and Locating Batteries
Select batteries that meet or exceed the total ampere hours calculated in Table 5-4 . The control
panel can charge batteries in the 7 AH to 26 AH range. The control panel cabinet is capable of
housing batteries up to 18 AH. Batteries larger than 18 AH require the BB-26, BB-55 or other UL
listed external battery cabinet.
102

Calculating the Battery Size

Required Standby Time
(24 hours)
X[
Required Alarm Time
(for 5 min., enter 0.084,
for 10 min., enter 0.168)
X[
] =
=
]
=
X 1.2
=
MRP-2001 & MRP-2001E PN 53040:A 4/16/2007
Calculating the Battery Size
AH
AH
AH
AH