Table of Contents
Advertisement
Customising Riding Modes: DQS enable/
disable
The ABS customisation page is only available for the
bikes equipped with the DQS. This function disables
or enables the DQS for the selected riding mode.
Enter the Setting MENU.
Select "RIDING MODE" option, by pressing button
(1) or (2). Once function is highlighted, press
CONFIRM MENU button (4). You open the "RIDING
MODE" menu.
Select the desired riding mode (RACE, SPORT or
WET), by pressing button (1) or (2).
Once desired mode is highlighted, press CONFIRM
MENU button (4).
You open the selected riding mode customisation
Menu. Select the parameter to be customised (DQS),
by pressing button (1) or (2). Once desired parameter
is highlighted, press CONFIRM MENU button (4).
When opening this function, DQS currently set status
is shown on the left (e.g.: DQS ON).
Customisation options are listed on the right: status
ON and OFF.
Press buttons (1) and (2) to highlight the statuses one
by one: in particular, use button (1) to highlight the
following item and button (2) to highlight the previous
item.
Once desired status is selected, press CONFIRM
MENU button (4) to highlight MEMORY item.
112
To save the new setting, hold button (4) for 3
seconds while the MEMORY item is highlighted in
orange. If new settings have been saved,
MEMORIZED will be shown in green for 1 second,
the set status will be refreshed (refresh is indicated
with the green colour) and then EXIT will be
highlighted in green.
To exit the menu and go back to previous page,
select EXIT and press button (4).
1
2
4
fig. 63
Advertisement
Table of Contents
