Switching The Hdmi Output; Checking Your System Settings; Resetting The System - Pioneer SC-LX81 Operating Instructions Manual

Using other functions

Switching the HDMI output

SC-LX81 only
Set which terminal to use when outputting video and
audio signals from the HDMI output terminals (HDMI
OUT1, HDMI OUT2 or HDMI OUT ALL).
The HDMI OUT1 terminal is compatible with the HDMI
control function.
SOURCE SOURCE
TV TV RCV RCV
CH VOL
VOL
• Set the operation selector switch to RCV, then press
HDMI OUT.
Please wait a while when Please wait ... is displayed.
The output switches among HDMI OUT1, HDMI OUT2
and HDMI OUT ALL each time the button is pressed.

Checking your system settings

Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
SOURCE SOURCE
TV TV RCV RCV
CH VOL
VOL
1 Set the operation selector switch to RCV, then press
STATUS to check the system settings.
These appear on the front panel display.
The front panel display shows each of the following
settings for two seconds each:
Input source
Surround Back Processing
MCACC preset
ZONE 2 input
ZONE 3 input
HDMI Control
HDMI OUT
Note
1 • Synchronized amp mode on page 88 is canceled when the HDMI output is switched. If you wish to use the synchronized amp mode, switch
to HDMI OUT1, then select the synchronized amp mode on the flat panel TV using the flat panel TV's remote control.
• When the power is turned off then back on after switching the HDMI output, the input is set to a setting between HDMI1 and HDMI3, or BD.
2 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
SIGNAL SEL SLEEP DIMMER AUDIO
SR+ SBch MCACC
DISP
A.ATT A.ATT GENRE HDMI OUT
CH
D.ACCESS CLASS
ENTER
CLR
1
PTY
SEARCH RETURN
HOME
MENU
TUNE
iPod CTRL
STATUS STATUS PHASE CTRL CH LEVEL
THX MPX EON
AUTO/ STEREO/
DIRECT A.L.C. STANDARD ADV SURR
PGM
BD MENU
2
↓
↓
↓
↓
↓
↓
2 When you're finished, press STATUS again to
switch off the display.

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
1 Switch the receiver into standby.
2 While holding down HOME MENU on the front
panel, press  STANDBY/ON.
The display shows RESET  NO .
3 Press ENTER on the front panel.
Select 'RESET' using /, then press ENTER on
4
the front panel.
The display shows RESET? OK.
5 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
13
97
En