Controlling The Rest Of Your System; Setting The Remote To Control Other Components; Selecting Preset Codes Directly - Pioneer SC-LX81 Operating Instructions Manual

Controlling the rest of your system

Chapter 14:
Controlling the rest of your system
Setting the remote to control other
components
Most components can be assigned to one of the input
source buttons (such as DVD or CD) using the
component's manufacturer preset code stored in the
remote.
However, there are cases where only certain functions
may be controllable after assigning the proper preset
code, or the codes for the manufacturer in the remote
control will not work for the model that you are using.
If you can't find a preset code that matches the
component you want to control, you can still teach the
remote individual commands from another remote
control (see Programming signals from other remote
controls below).
Note
• You can cancel or exit any of the steps by pressing
MULTI OPERATION. To go back a step, press
RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.

Selecting preset codes directly

MAIN MAIN
RECEIVER SOURCE
ZONE2 ZONE2 3 3
MULTI MULTI
OPERATION OPERATION
DVD DVD BD BD DVR1 TV DVR2 DVR1
VIDEO1 VIDEO1 VIDEO2 VIDEO2 VIDEO3 VIDEO3 DVR2 TV
HOME MEDIA HOME MEDIA
GALLERY GALLERY CD CD CD-R CD-R PHONO PHONO
INPUT SELECT
HDMI HDMI TUNER TUNER
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows SETUP.
Use / to select PRESET, then press ENTER.
2
Note
1 You can't assign TUNER or HOME MEDIA GALLERY.
2 • When using a Pioneer HDD recorder, please select PIONEER DVR 487, 488, 489 or 493.
• When using a Pioneer flat screen TV released prior to summer 2005, please select preset codes 637 or 660.
SOURCE
TV RCV
CH VOL
VOL
TV CONTROL
INPUT MUTE MUTE
AUDIO VIDEO
PARAMETER PARAMETER
TUNE +
EXIT TOOLS
TOP MENU MENU
BAND T.EDIT
ST ENTER ENTER ST +
PTY
SEARCH RETURN
HOME
MENU
TUNE
iPod CTRL
STATUS PHASE CTRL CH LEVEL
3 Press the input source button for the component
you want to control, then press ENTER.
When assigning preset codes to TV CONTROL, set the
operation selector switch to TV here.
The LCD on the remote displays the component you want
to control (for example DVD or TV).
Use / to select the first letter of the brand name
4
of your component, then press ENTER.
This should be the manufacturer's name (for example, P
for Pioneer).
Use / to select the manufacturer's name from
5
the list, then press ENTER.
Use / to select the proper code from the list,
6
then try using this remote with your component.
The code should start with the component type (for
example, DVD 020). If there is more than one, start with
2
the first one.
To try out the remote control, switch the component on or
off (into standby) by pressing SOURCE. If it doesn't
seem to work, select the next code from the list (if there
is one).
• If you can't find or properly enter a preset code, you
can still teach the remote individual commands from
another remote control (see Programming signals
from other remote controls below).
7 If your component is controlled successfully, press
ENTER to confirm.
The remote LCD display shows OK.
1
14
99
En