Resetting The Remote Control Presets; Confirming Preset Codes; Renaming Input Source Names; Direct Function - Pioneer SC-LX81 Operating Instructions Manual

Controlling the rest of your system
5 Repeat step 4 to erase other buttons.
6 Press and hold MULTI OPERATION for a couple of
seconds when you're done.

Resetting the remote control presets

This will erase all preset remote control preset codes and
1
programmed buttons.
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows SETUP.
Use / to select RESET, then press ENTER.
2
RESET flashes in the LCD display.
3 Press and hold ENTER for about two seconds.
The LCD shows OK to confirm the remote presets have
been erased.

Confirming preset codes

Use this feature to check which preset code is assigned
to an input source button.
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows SETUP.
Use / to select READ ID, then press ENTER.
2
The LCD on the remote prompts you for the input source
button you want to check.
3 Press the button of the component for which you
want to check the preset code, then press ENTER.
The brand name and preset code appears in the display
for three seconds.

Renaming input source names

You can customize the names that appear on the remote
LCD when you select an input source (for example, you
could change the name of DVR 1 to HDD/DVR).
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows SETUP.
Use / to select RENAME, then press ENTER.
2
The LCD on the remote prompts you for the button of the
input source you want to rename.
Note
1 When Selecting preset codes directly on page 99 are set, all the signals learned in the input source buttons are cleared. This function is
convenient when you want to reset some but not all of input source buttons.
3 Press the input source button you want to rename
then press ENTER.
Use / to select NAME EDT, then press ENTER.
4
To reset the button to its original (default) name, select
NAME RST above.
5 Edit the name of the input source in the remote
control LCD, pressing ENTER when you're finished.
Use / to change the character and / to move
forward/back a position. The name can be up to eight
characters (the possible characters are listed below).
ABCDEFGHIJKLMNOPQRSTUVWXYZ
0123456789 \ / * + – [space]

Direct function

• Default setting: ON
You can use the direct function feature to control one
component using the remote control while at the same
time, using your receiver to playback a different
component. This could let you, for example, use the
remote control to set up and listen to a CD on the
receiver, and then use the remote control to rewind a
tape in your VCR while you continue to listen to your CD
player.
When direct function is on, any component you select
(using the input source buttons) will be selected by both
the receiver and the remote control. When you turn direct
function off, you can operate the remote control without
affecting the receiver.
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows SETUP.
Use / to select DIRECT F, then press ENTER.
2
The LCD on the remote prompts you for the button of the
input source you want to control.
3 Press the input source button for the component
you want to control, then press ENTER.
Use / to switch direct function ON or OFF, then
4
press ENTER.
The LCD shows OK to confirm the setting.
14
101
En