81262_2.book Page 11 Friday, November 11, 2005 11:11 AM
Chapter 3: Installation
This chapter describes how to install the ST60+ Depth instrument, and associated
depth transducer. The transducer is fitted in the hull of the vessel and is connected
by cable to the rear of the instrument. The actual type of transducer depends on
the type of hull in which it is to be installed.
For advice, or further information regarding the installation of this equipment,
please contact the Raymarine Product Support Department or your own National
Distributor.
3.1 Planning your installation
Before starting the installation, spend some time considering the best positions
for both transducer and instrument, such that the
EMC installation guidelines
Site requirements
Transducer
Depth transducer dimensions
The transducer types required for the various hull types are as follows:
Site Requirements
(below) are satisfied.
2.94 in (75 mm )
diameter
2.0 in (51 mm )
diameter
2.94 in (75 mm )
diameter
11
and the
D8685-1