81262_2.book Page 13 Friday, November 11, 2005 11:11 AM
Chapter 3: Installation
• Be as near as possible to the center line of the vessel.
• Be clear of other through-hull fittings or projections.
• Have sufficient clearance inside the hull to fit the nut.
• Have 4 in (100 mm) of headroom to allow for withdrawal.
• Be within 10
There must also be a viable route for the transducer cable to be routed to the
instrument.
Maximum transducer angle
Instrument
CAUTION: Keep the rear of the instrument dry
Keep the rear of instrument dry. Failure to observe this caution
could result in damage if water enters the instrument through
the breathing hole or comes into contact with the electrical
connectors.
ST60+ instruments can be fitted either above or below deck, provided the rear of
the instrument is sited where it is protected from contact with water.
Each instrument must also be positioned where:
• It is easily read by the helmsman.
°
of the vertical, forward, aft and athwart ships.
10˚ maximum
13
D4350-1