Alarms - Raymarine ST60+ Owner's Handbook Manual

81262_2.book Page 3 Friday, November 11, 2005 11:11 AM
Chapter 1: Operation
The screens show the maximum/minimum depth since the last reset, but time out
to the current depth screen if no user action occurs for 8 seconds.

Alarms

An alarm condition occurs if:
• The depth is less than the SHALLOW or SHALLOW anchor level.
• The depth is more than the DEEP anchor level.
• The DEEP level value is crossed (when the seabed rising or falling).
Deep anchor
alarm
To adjust an alarm level:
1.
offset
to enter adjust mode.
Depth alarms
An alarm condition is indicated by an audible beep and a flashing alarm
symbol ( ) on the display. The display will also show the relevant caption, either
SHALLOW or DEEP , and for anchor alarms an anchor symbol ( ).
Note:
You can access alarm screens only at master instruments.
On repeaters, the alarm button has no effect.
Shallow alarm
You can change the shallow alarm
alarm
only if the shallow alarm lock is set
OFF during User calibration
= Alarm enabled
To enable/disable any alarm, select the
relevant screen then hold down
Shallow anchor
alarm
alarm
Select relevant In adjust mode, use
2.
screen then press either
+
reset offset
to set the alarm level
alarm
alarm
= Anchor alarm
reset
for 1 second
To leave adjust mode
Press
offset
or
reset
3
Deep
alarm
alarm
+
reset