Grandstream Networks HT503 FXO User Manual page 40

Allow DHCP option 66 to
override server
Automatic Upgrade
Authenticate Conf File
Firmware Key
SIP TLS Certificate
SIP TLS Private Key
SIP TLS Private Key
Password
ACS URL
ACS Username
ACS Password
Periodic Inform Enable
Periodic Inform Interval
Connection Request
Username
Connection Request
Password
Connection Request
Port
CPE SSL Certificate
CPE SSL Private Key
System Ring Cadence
Call Progress Tones
FIRMWARE VERSION 1.0.12.4
will be downloaded.
If set to "Yes", configuration and upgrade server information can be obtained using
DHCP option 66 from DHCP server located in customer's environment
Choose "Yes" to enable automatic upgrade and provisioning. When set to No, HT503
will only do upgrade once at boot up.
When "Check every day" or "Check every week" is checked, user can specify "Hour of
the day(0-23)" or "Day of the week(0-6)". Default time is Monday 1AM.
There are three options to choose from: "Always check for New Firmware at Boot up",
"Check New Firmware only when F/W pre/suffix changes", and "Always Skip the
Firmware Check".
This protects the configuration from an unauthorized change. If set to "Yes, the
configuration file is authenticated before acceptance.
Key for firmware encryption. (32 digits in hexadecimal format. End users should keep it
blank.
The user specify SSL certificate used for SIP over TLS in X.509 format.
The user specify SSL private key used for SIP over TLS in X.509 format.
User specify password to protect the private key above.
User specify the Auto Configuration Server's URL (TR-069 protocol)
User specify the ACS Username
User specify the ACS password
Default is No. If set to YES, device will send inform packets to the ACS
Frequency that the inform packets will be sent out to the ACS
Set a user name for the ACS to connect to this device
Set a password for the ACS to connect to this device
Set a port number for the ACS to connect to this device, default is 7547
Configure the SSL authentication of Customer-premises equipment
Configure the SSL Private Key of Customer-premises equipment
Configuration option for FXS port ring cadence for all incoming calls. (Syntax:
c=on1/off1-on2/off2-on3/off3; )
Note : Maximum supported cadences is 3
Using these settings, users can configure tone frequencies according to their
preference. By default they are set to North American frequencies.
These tones should be configured with known values to avoid uncomfortable high pitch
HT503 USER MANUAL
Page 38 of 64