Vinotemp Wine-Mate WM-1500HTD Installation, Use & Care Manual page 15

6. Parameter Programming
1) Press and hold the SET +
then release the keys.
2) Press and hold again the SET +
release the keys. The first parameter Hy will be displayed.
3) Press up/down keys
4) Press the "SET" key to display its value.
5) Use up/down keys
6) Press "SET" to store the new value and the display will flash 3 times.
7) To exit: Press SET +
PARAMETER
Set
Hy
temperature regulation differential
AC
Con compress on with probe faulty (min)
CoF compress off with probe faulty (min)
CF
rES
dLy temperature display delay (min)
ot
LS
US
idF defrost cycle interval time (hour)
MdF defrost cycle endurance time (min)
ALC
ALU
ALL
AFH
alarm recovery differential
ALd temperature alarm delay (min)
dAO temperature alarm delay on startup (hr)
SAA
SHy heater regulation differential
FSU
FnC
Fon fan on with compressor off (min)
FoF fan off with compressor off (min)
NOTE: Depending on the controller, not all parameters are used.
7. How to calibrate the air probe
If the actual cellar temperature differs from the setting temperature, set
parameter ot = actual cellar temperature minus set-point.
8. How to adjust defrost cycle
keys until the "°C" or "°F" LED starts flashing,
/ to scroll to the required parameter within 10 sec.
to change its value within 10 sec.
or wait 15sec without pressing a key.
DESCRIPTION
°
set-point ( )
anti-short cycle delay (min)
°F/ °C
temperature unit (
display resolution
°
probe calibration ( )
°
minimum set-point ( )
°
maximum set-point ( )
temperature alarm type
high temperature alarm (
low temperature alarm (
°
heater set-point ( )
fan action
fan operating mode
keys until the Pr2 label is displayed, then
DEFAULT VALUE
°
( )
)
rE: relative to set-point
°
)
°
)
°
( )
°
( )
C-n: on with compressor & off during defrost
- 14 -
55
4
10
15
30
F: Fahrenheit
in: integer
1
0
50
65
12
30
10
10
5
60
23
40
4
Std
0
15