Installing The Appliance - Baumatic BKF24ID Instruction Manual

Installing the appliance

o Cut a hole in the worktop that corresponds with the drawing
shown above.
o If the hob is being installed without an oven below it, a
separator panel must be placed between the bottom of the hob
and the housing below it, at a minimum distance of 10 mm.
o If the hob is being installed with an oven below it, place a
separator panel at a minimum distance of 15 mm and follow the
oven manufacturer's
aeration is provided.
o The heat produced by the oven, measured on the right side of
the bottom of the hob, must be lower than 60°C otherwise the
heat could damage the touch control panel.
o IMPORTANT: You must observe the ventilation requirements
shown in the drawing below.
instructions, ensuring
25
that sufficient