Key Function; Operation Procedures - Healthstream CHEETAH / 402BK Owner's Manual

USE
The seat height can be adjusted by removing the adjustment knob and raising or
lowering the seat. There are 7 holes in the seat post allowing for a range of heights.
Once the correct height has been chosen, refit the adjustment knob and tighten. The
tension control knob allows you to alter the resistance of the pedals. A high resistance
makes it more difficult to pedal; a low resistance makes it easier. For the best results
set the tension while the bike is in use.
Monitor or console
TIME (TMR).............................................00:00-99:59 MIN
SPEED (SPD).............................................0.0-99.9KM/H
DISTANCE "DST"....................................0.00-999.9KM
CALORIES "CAL"....................................0-9999KCAL
PULSE......................................................40-240BPM

KEY FUNCTION:

MODE: This key lets you to select and lock on to a particular function you want.
RECOVERY: Press to start or stop the operation of functions.
SET: The key allows you to choose a target value for TIME.
DISTANCE, CALORIES & PULSE.
RESET: Reset the value to zero by pressing the key.

OPERATION PROCEDURES:

1. AUTO ON/OFF:
▲The system turns on when any key is pressed or when it receives an input from
the speed sensor.
▲The processor turns off automatically when the speed sensor has no signal input
or no key is pressed for approximately 4 minutes.
2. RESET:
The unit can be reset by changing the batteries or pressing the RESET key for 3
seconds.
3. HOW TO PRESET TIME, DISTANCE,PULSE & CALORIES:
Press the MODE key until the function brand which is going to be preset is
flashing.
Press the MODE key once the function brand stop flashing.
Next, choose the value you want to exercise by the SET key.
When the speed sensor has any signal input. The monitor will begin to count
down.
It will beep for 10 seconds to indicate the completion of workout which is preset,
press any key to stop beeping.
10