Component Identification - Shark SSG-503027E Operator's Manual

Quick
Coupler
Discharge
Nipple
Burner Fuel
Tank
Spray Gun
Pressure
Hose
Pump — Delivers a specific gpm to the high pressure
nozzle which develops pressure.
Starter Grip— Used for starting the engine manually.
Spray Gun — Controls the application of water and
detergent onto cleaning surface with trigger device. In-
cludes safety latch.
Unloader Valve— Safety device which allows pres-
sure to be released when spray gun is closed.
Wand — Must be connected to the spray gun.
6
COMPONENT IDENTIFICATION SMALL
Flue Adapter
Optional 7-10049
Insulation Gasket
Optional 7-01471
Pressure
Nozzles
Detergent
Valve
Trigger
High
97-6142, 97-6134 • REV. 9/04
Nozzle Quick
Wand
Coupler
Starter Grip
High Pressure Hose — Connect one end to water
pump discharge nipple and the other end to spray gun.
Adjustable Thermostat — Safety control which pre-
vents temperatures from going above adjustable set-
ting.
Note: If trigger on spray gun is released for more than
2 minutes, water will leak from valve. Warm water will
discharge from pump protector onto floor. This sys-
tem prevents internal pump damage.
Note: if flue adapter is installed, the burner assembly
air adjustment must be adjusted.
Water
Supply Hose
(not included)
Adjustable
Thermostat
Burner
Switch
Hour Meter
Pump
Unloader Valve