Control Panel - Supero SuperServer 5015M-UR User Manual

S S
UPER ERVER 5015M-UR/5015M-U/5015M-NTR/5015M-NT User's Manual
Figure 6-1. Chassis: Front and Rear Views
Slim DVD-ROM Drive
Power Supply Module
Mouse/Keyboard
Note: the SC815TQ-560U chassis (5015M-U/5015M-NT) has only a single power supply mod-
ule.
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications.
These wires have been bundled together as a ribbon cable to simplify the connec-
tion. Connect the cable from JF1 on the serverboard to the appropriate header on
the Control Panel PCB (printed circuit board). Make sure the red wire plugs into
pin 1 on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1
can be found in "Chapter 5: Advanced Serverboard Setup."
Slim Floppy Drive (optional)
SATA Drive Bays
USB Ports
COM1 Port VGA Port
6-2
System LEDs
System Reset
PCI Expansion Slots (w/ riser cards)
Ethernet Ports
Control Panel
Main Power