Toshiba digital copiers Service Manual page 22

2
2-6
Using the GA-1121 Control Panel
Resume Printing —Resumes printing after interrupting the print job in order to make
copies.
Shut Down —When you select this option, you can choose from the following:.
• Restart Server —Resets the GA-1121 system software but does not reboot the
entire system. Network access to the GA-1121 is temporarily interrupted and
all currently processing jobs are aborted and might be lost.
• Shut Down System —Shuts down all GA-1121 activity properly so that you can
power off the system using the main power switch on the copier. You should
always select this option before powering off the copier.
• Reboot System —Shuts down all GA-1121 activity properly and then restarts.
Run Setup —allows you to access the Setup options in order to configure the network and
printing environment. Typically it is the network administrator's responsibility to
configure Setup according to the network and user environment. See the GA-1121 user
documentation for a list of options and detailed descriptions of each Setup option.
Setup is required the first time the copier is powered on and after GA-1121 system
N :
OTE
software is installed. You must save changes to Server, Network, and Printer Setup after
installing system software.
Run Diagnostics —When you select this option, you can run the following tests:
• Video Diagnostics —Runs diagnostics on the image processing capabilities of
the GA-1121.
• Test E-mail —Runs diagnostics on the e-mail printing feature. For more
information about e-mail printing, see the GA-1121 user documentation.
Tray Alignment— Use this feature to align input trays for printing. Aligning the trays
helps to center an image on the printed page or to match the front and back images of a
duplex printed page. For more information, see the Job Management Guide.
—Accesses the Calibration menus. Requires a password, if one has been set.
Calibration
For more information, see the GA-1121 user documentation.