Connecting To The Console Port; Table 4: Serial Converter Wiring; Figure 16: Console Port Connection - Edge-Core ECS4610-24F Installation Manual

| Installing the Switch
C 3
HAPTER

Connecting to the Console Port

C
ONNECTING TO THE
This port is used to connect a console device to the switch through a straight-
through UTP cable and an RJ-45-to-DB-9 serial converter. The console device
can be a PC or workstation running a VT-100 terminal emulator, or a VT-100
terminal. An RJ-45-to-DB-9 converter is supplied with the unit for connecting to
a RS-232 serial DB-9 DTE port, as illustrated below. The pin assignments used in
the RJ-45-to-DB-9 converter are described below.

Figure 16: Console Port Connection

PC's DB-9 Com Port
RJ-45-to-DB-9
Serial Converter
W M
IRING AP FOR
The following table describes the pin connections for the RJ-45-to-DB-9 serial
converter. The converter should be used with straight-through UTP or STP
Ethernet cable.

Table 4: Serial Converter Wiring

8-PIN RJ-45 Port
(Switch Console Port)
6 TXD (transmit data)
3 RXD (receive data)
4 SGND (signal ground)
C
ONSOLE
Straight-through
UTP Cable with
RJ-45 Connectors
S C
ERIAL ONVERTER
Null Modem
------------------------>
<-----------------------
--------------------------
– 46 –
P
ORT
9-PIN DB-9 Port
(PC's DTE Com Port)
2 RXD (receive data)
3 TXD (transmit data)
5 SGND (signal ground)
Switch's RJ-45
Console Port