Table of Contents
Advertisement
CLIO Service Manual
5.18.2.
I
PWB U
NVERTER
1.
Solder the backlight wires to the Inverter PWB Unit (11), taking care to solder them in the
proper order.
2.
Place the Inverter PWB Unit (11) into position, then rotate 90 degrees clockwise (to
vertical) and re-fasten the orange Display Connection FPC plug. Rotate the Inverter
PWB Unit (11) back into position.
3.
Insert the two #1 Phillips head (10)(K2.2x6.5) head screws in their holes, and torque
them to 0.2N.M using a #1 Phillips head screwdriver.
4.
Follow the Display Top refit procedure, above. Be sure to coil the Display connection
FPC (8) twice before plugging it in if it was not pre-coiled.
5.19.
D
ISPLAY
Please refer to photos 5, 12, 22 in Chapter 2.
5.19.1.
D
C
ISPLAY
ONNECTION
1.
Follow the Display Top removal procedure, above.
2.
Unplug the orange Display Connection FPC (8) from the lower right corner of the Main
PWB Unit (50).
3.
Follow the Display Bezel removal procedure, above.
4.
Follow Steps 1-4 of the Inverter PWB Unit (11) removal procedure, above.
5.
Unplug the Display Connection FPC (8) from the LCD Unit (66) and carefully peel away
the tape securing the Display Connection FPC (8) to the LCD Unit (66). Store the
Display Connection FPC (8) in a secure location.
5.19.2.
D
C
ISPLAY
ONNECTION
1.
Plug the Display Connection FPC (8) into the LCD Unit (66), taking care to avoid
damaging the plug.
2.
Secure the flex circuit (8) in position by taping it to the LCD Unit (66).
3.
Follow Steps 2-4 of the Inverter PWB Unit refit procedure, above.
4.
When replacing the Display Connection FPC (8), be sure to coil it twice just outside the
LCD Bezel opening if the FPC (8) did not come pre-coiled.
5.
Follow the Display Top refit procedure, above.
6.
Follow the Keyboard base Bottom refit procedure, above.
5.20.
B
OTTOM
Please refer to photos 4, 7, 9, 12, in Chapter 2.
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthonyh@ashlandhome.net
– R
NIT
EFIT
C
FPC – R
ONNECTION
FPC – R
EMOVAL
FPC – R
EFIT
H
– R
INGE
EMOVE
5-13
CLIO Tear-down & Rebuild
& R
EMOVE
EFIT
& R
EFIT
Advertisement
Table of Contents
