Table of Contents
Advertisement
CLIO Service Manual
5.
Gently rotate the Inverter PWB Unit (11) clockwise 90 degrees (to vertical) and unplug
the Display Connection FPC (8)(flex circuit) cable. Move the Indicator PWB Unit (8) to the
left, away from the CLIO unit. Use caution to avoid damaging the backlight flex circuit
wires. Optionally, you may un-solder the backlight wires from the Inverter PWB board
(11)(note the order in which the wires were soldered prior to removing them) and store
the Inverter PWB Unit (11) in a secure location.
6.
Carefully peel off the tape securing the orange Display Connection FPC to the back of
the LCD Unit (16) and unplug the Display Connection FPC from the LCD Unit (66); move
the Display Connection FPC out of the way, using caution to avoid damaging the flex
circuit.
7.
Grasp the Upper Hinge (16) and lift it straight up. Store in a secure location.
8.
Gently lift the LCD Unit (66) straight up and store in a secure location.
9.
Remove the Display Bezel (2).
5.11.2.
D
B
ISPLAY
EZEL
1.
Ensure the CLIO unit is oriented properly (keyboard facing up and away from the
technician).
2.
Place a piece of soft cloth on top of the CLIO Keyboard Top (47) to avoid scratching or
marring the LCD Unit (66) or Display Bezel (2).
3.
Place the Display Bezel (2) into position on top of the CLIO Keyboard Top (47).
4.
Gently lower the LCD Unit (16) into position inside the Display Bezel (2).
5.
Insert the Upper Hinge (16) into position, using caution to avoid damaging the LCD Unit
(66). Insert two K2.2x6.5 screws (10) into their holes and loosely fasten them using a #1
Phillips head screwdriver.
6.
Lay the orange Display Connection FPC into position above the LCD Unit (66).
7.
If the Inverter PWB Unit (11) was un-soldered from the backlight wires during the Display
Bezel removal procedure, re-solder the backlight wires taking care to re-solder them in
the same order as before their removal.
8.
Place the Inverter PWB Unit (11) into position, then rotate 90 degrees clockwise (to
vertical) and re-fasten the orange Display Connection FPC plug. Rotate the Inverter
PWB Unit (11) back into position.
9.
Insert the two remaining K2.2x6.5 screws (10) in their holes, and fasten all four screws to
0.2N.M using a #1 Phillips head screwdriver.
10.
Connect the Display Connection FPC to the LCD Unit (66).
11.
Tape the Display Connection FPC into place against the LCD Unit (66).
12.
Follow the Display Top refit procedure, above.
5.12.
LCD U
NIT
Please refer to photos 4-6, 22, 23, 27 in Chapter 2.
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthonyh@ashlandhome.net
– R
EFIT
– R
& R
EMOVE
EFIT
5-9
CLIO Tear-down & Rebuild
Advertisement
Table of Contents
