Table of Contents
Advertisement
CLIO Service Manual
metal plate facing up; the main board should have the ROM and RAM modules facing
up).
2.
Ensure that the Bottom Hinge (43, 44) is in place on the Keyboard Base Top (47). Refer
to the Bottom Hinge Remove & Refit procedure (below).
3.
Place the protective plastic mat on the Keyboard Base Top (47), ensuring that the four
holes in the mat line up with the four screw holes in the Keyboard Base Top (47).
4.
Place a piece of soft cloth over the LCD Unit (66) to avoid marring or scratching the LCD
Unit (66) or assembly.
5.
Place the Keyboard Base Top (47) on top of the LCD Assembly in standard orientation
(the large opening for the keyboard should be facing away from you and the battery well
should be aligned with the bottom edge of the LCD Unit
6.
Grasp the Keyboard Assembly (40)(silver metal plate) gently but firmly in your right hand.
Grasp the Main PWB Unit (50) gently but firmly in your left hand. Lift both assemblies
straight up in unison taking care to avoid bending or breaking the Indicator PWB Unit (51,
52, 53) and keyboard ribbon cables.
7.
Rotate the two assemblies in unison 90 degrees counterclockwise, taking care to avoid
overextending the flex circuits (8).
8.
Lower both assemblies straight down onto the Keyboard Base Top (47). Ensure that
both the Main PWB Unit (50) and Keyboard Assembly (40) line up with the screw holes in
the Keyboard Base Top (47).
9.
Using tweezers or a pair of miniature needle-nose pliers, gently insert the Indicator PWB
Unit (51, 52) into its slot in the center of the front (facing away from you) edge of the
Keyboard Base Top (47).
10.
Follow the Keyboard Base Bottom refit procedure (above).
5.10.
D
ISPLAY
Please refer to photos 4-6, 22, 23, 27 in Chapter 2.
5.10.1.
D
T
ISPLAY
OP
1.
Place the CLIO unit on a flat level work surface in standard orientation.
2.
Using either a flat headed jewelry screwdriver or the tip of an X-Acto blade, gently
remove the four rubber plugs (19, 20, 21, 22)(located on the CLIO hinge arms by
inserting the implement between the caps and the hinge and carefully prying the plugs
loose. Store in a secure location. Removing these caps will reveal four screws.
3.
Remove the four screws (17, 24) located in the previous step using a #2 Phillips head
screwdriver and store in a secure location. Remove the washers (18, 23) and store in a
secure location.
4.
Remove the two lower hinge arm halves (25, 26) by lifting them straight up and away
from the CLIO unit.
5.
Grasping the CLIO unit securely, turn it upside-down. The Display Bezel Top (1) will now
be on top.
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthonyh@ashlandhome.net
T
– R
& R
OP
EMOVE
– R
EMOVAL
5-7
CLIO Tear-down & Rebuild
EFIT
Advertisement
Table of Contents
