Table of Contents
Advertisement
CLIO Service Manual
5.
Using tweezers or a pair of miniature needle-nose pliers, gently grasp the Inverter PWB
Unit (51, 52) and insert it straight into its slot. Secure the Inverter PWB Unit ribbon cable
(53) in position above the Keyboard Assembly (40) with tape.
6.
Follow the Keyboard Base Bottom refit procedure, above.
5.24.
M
PWB U
AIN
Please refer to photos 2, 3, 12, 17, 21 in Chapter 2.
5.24.1.
M
PWB U
AIN
WARNING: THIS PROCEDURE ASSUMES THAT DATA STORED ON THE CLIO UNIT
HAS BEEN SYNCHRONIZED OR HAS ALREADY BEEN CORRUPTED BEYOND
RECOVERABILITY. FOLLOWING THIS PROCEDURE WITHOUT SYNCHRONIZING
USABLE DATA WILL RESULT IN THE LOSS OF THAT DATA.
1.
Follow the Keyboard Base Bottom removal procedure, above.
2.
Follow Steps 3-6 of the Keyboard Assembly removal procedure, above.
3.
Unplug the orange Display connection FPC (8)(flex circuit) cable from its plug on the
lower right corner of the Main PWB Unit (50).
4.
Un-solder the backlight wires from the Main PWB Unit (50), noting the order in which they
were fastened.
5.
Grasp the ROM PWB Unit (67) using fingernails and lift it straight up and away from the
Main PWB Unit (50). Store in a secure location. Repeat for the RAM PWB Unit (54).
6.
Grasp the Modem PWB unit (55) using fingernails and lift it straight up and away from the
Main PWB Unit (50). Store in a secure location.
7.
Follow the Indicator PWB removal procedure, above.
8.
Follow the Indicator PWB ribbon cable removal procedure, above.
9.
Follow the Speaker removal procedure, above.
10.
Follow the Bottom Hinge removal procedure, above.
11.
Lift the Main PWB Unit (50) straight up and away from the Keyboard Base Top (47).
Store in a secure location.
5.24.2.
M
PWB U
AIN
1.
Lower the Main PWB Unit (50) into position in the Keyboard Base Top (47), taking care
to line up the two holes in the middle of the Main PWB Unit (50) with the two screw
mounting studs in the middle of the Keyboard Base Top (47).
2.
Follow the Bottom Hinge refit procedure, above.
3.
Follow the Speaker refit procedure, above.
4.
Follow the Indicator PWB Unit ribbon cable refit procedure, above.
5.
Follow the Indicator PWB Unit refit procedure, above.
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthonyh@ashlandhome.net
– R
NIT
EMOVE
– R
NIT
EMOVAL
– R
NIT
EFIT
5-16
CLIO Tear-down & Rebuild
& R
EFIT
Advertisement
Table of Contents
