Table of Contents
Advertisement
CLIO Service Manual
6.
Grasp the Modem PWB Unit (55) using fingernails and lower it straight down onto the
Main PWB Unit (50). Use caution to avoid damaging the plugs. Snap into position.
7.
Grasp the ROM PWB Unit (67) using fingernails and lower it straight down onto the Main
PWB Unit (50), using caution to avoid damaging the plugs. Snap into place. Repeat for
the RAM PWB Unit (54).
8.
Solder the backlight wires (53) onto the Main PWB Unit (50) in the proper order.
9.
Plug the orange Display Connection FPC (8)(flex circuit) cable into its plug on the lower
right corner of the Main PWB Unit (50). Use caution to avoid damaging the plug. Snap
into place.
10.
Follow the Keyboard Assembly refit procedure, above.
11.
Follow the Keyboard Base Bottom refit procedure, above.
5.25.
L
H
OWER
Please refer to photos 4-6 in Chapter 2.
5.25.1.
L
H
OWER
INGE
1.
Place the CLIO unit on a flat level work surface in standard orientation.
2.
Using either a flat headed jewelry screwdriver or the tip of an X-Acto blade, gently
remove the four rubber plugs (19, 20, 21, 22) located on the CLIO Lower Arms (25, 26)
by inserting the implement between the caps and the hinge and carefully prying the caps
loose. Store in a secure location. Removing these plugs will reveal four screws.
3.
Remove the four screws (17, 24) and the washers (18, 23) located in the previous step
using a #2 Phillips head screwdriver and store in a secure location.
4.
Remove the two hinge arm halves (25, 26) by lifting them straight up and away from the
CLIO unit.
5.25.2.
L
H
OWER
INGE
1.
Lay the right side lower hinge arm (26) in place, taking care to avoid pinching the flex
circuit (8) and wires. Replace the washers (18, 23). Fasten the arm in place using two
screws (17, 24) (one each M3x6 upper, and M3x10 lower) and a #2 Phillips head
screwdriver. Replace the rubber plugs (19, 21) above the screws.
2.
Repeat the above step for the left side. Note that there are no flex circuits on the left
side.
5.26.
M
A
ETAL
Please refer to photos 4-6 in Chapter 2.
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthonyh@ashlandhome.net
A
– R
INGE
RMS
EMOVE
A
– R
RMS
EMOVAL
A
– R
RMS
EFIT
– R
& R
RM
EMOVE
5-17
CLIO Tear-down & Rebuild
& R
EFIT
EFIT
Advertisement
Table of Contents
