Vadem Clio Service Manual page 105

CLIO Service Manual
6. S
TANDING
This section contains procedures that will affect units returned for service. Implementation of
these procedures may either be recommended or mandatory. These procedures reflect
changes and enhancements that may affect product safety, reliability, or usability.
6.1. LCD S
UPPORT
NOTE: This is a recommended procedure. Install the spacer any time maintenance is
performed on the LCD module.
A support spacer (P/N 200-001120-01 Rev. A) must be added to the backside of the Display
Enclosure Bezel (P/N 200-000116-00 Rev. A). This will support the LCD during flex circuit
(8) installation and will prevent damage tot he LCD. Installation of the spacer should be
performed during maintenance procedures involving LCD module repairs.
No special tooling or equipment is required.
6.1.1. M R
ATERIAL
Display Enclosure Bezel (P/N 200-000116-00 Rev A): one each
LCD Support (P/N 200-001120-01 Rev A): one each
6.1.2. P
ROCEDURE
Please refer to the pictures below.
1. Place Display Enclosure Bezel (2) upside-down with the hinge opening to left as shown
in the picture below. Use a flat surface that has a cutout to accommodate the curved
surfaces on both ends.
2. Peel off the protective liner from the back of the LCD Support. Place the LCD Support
against the 8 equally spaced ribs and align the starting point of the support such that it is
10.2mm nearer to you than the first rib. Refer to the picture below.
3. Push down firmly on the LCD Support to secure it in place.
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthonyh@ashlandhome.net
S
ERVICE
P
ROCEDURE
EQUIRED
6-1
Standing Service Procedures
P
ROCEDURES