Table of Contents
Advertisement
CLIO Service Manual
5.22.1.
S
– R
PEAKER
1.
Follow the Keyboard Base Bottom removal procedure, above.
2.
Carefully unplug the speaker wires (34) from the Main PWB Unit (50).
5.22.2.
S
– R
PEAKER
1.
Carefully plug the speaker wires (34) into the Main PWB Unit (50).
2.
Follow the Keyboard Base Bottom refit procedure, above.
5.23.
K
EYBOARD
Please refer to photo 12 in Chapter 2.
5.23.1.
K
A
EYBOARD
1.
Insert a piece of soft cloth between the CLIO Keyboard Top (47) and the LCD Assembly
to avoid scratching or marring the LCD Unit/Assembly.
2.
Follow the Keyboard Base Bottom removal procedure, above.
3.
Using tweezers or a pair of miniature needle-nose pliers, gently grasp the Indicator PWB
Unit (51, 52) and lift it straight up out of its slot.
4.
Gently peel off the tape securing the Indicator PWB Unit ribbon cable (53) to the
Keyboard Assembly (40). Bend the ribbon cable (53) back towards you, out of the way of
the Keyboard Assembly (40).
5.
Grasp the left and right sides of the Keyboard Assembly (40) and carefully lift it up and
out of the Keyboard Base Top (47).
6.
Carefully unplug the Keyboard Assembly ribbon cables from the Main PWB Unit (50) by
sliding the ribbon cables straight back (away from you) and out of the plugs. Store the
Keyboard Assembly (40) in a secure location.
5.23.2.
K
A
EYBOARD
1.
With one hand, orient the keyboard (40) properly (keys down, ribbon cables towards the
technician). Position the keyboard (40) at a slight angle just above its final position.
2.
Lift the Main PWB (50) slightly up and out of the Keyboard Base Top (47). Lay the
Keyboard Assembly (40) into position then rotate it towards you 90 degrees until the
keyboard (40) is vertical. Then, carefully slide the ribbon cables into the plugs on the
Main PWB Unit (50). Avoid using tools and use extreme caution to avoid damaging the
ribbon cable or connector. Repeat for the right ribbon cable.
3.
Rotate and lower the Keyboard Assembly (40) and Main PWB Unit (50) into position in
the Keyboard Base Top (47).
4.
Bend the Indicator PWB Unit ribbon cable (53) into position above the Keyboard
Assembly (40).
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - anthonyh@ashlandhome.net
EMOVAL
EFIT
A
– R
SSEMBLY
– R
SSEMBLY
EMOVAL
– R
SSEMBLY
EFIT
5-15
CLIO Tear-down & Rebuild
& R
EMOVE
EFIT
Advertisement
Table of Contents
