Control Locked - Kenmore 8519319A Use & Care Manual

l} y gs d©yce ps
Select the correct cycle and dryness level or temperature for your
load. If an Auto Dry Cycle is running, the display shows the
estimated cycle time when your dryer is automatically sensing
the dryness level of your load. If a Manual Cycle is running, the
display shows the exact number of minutes remaining in the
cycle.
Cool Down tumbles the load without heat during the last few
minutes of all cycles. Cool Down makes the loads easier to
handle and reduces wrinkling. The length of the Cool Down
depends on the load size and dryness level.
Drying tips
• Follow care label directions when they are available.
• if you use fabric softener sheets, use only ones labeled as
dryer safe. Follow package instructions.
• To reduce wrinkling, remove the load from the dryer as soon
as tumbling stops. This is especially important for permanent
press, knits, and synthetic fabrics.
• Avoid drying heavy work clothes together with lighter fabrics.
This could cause overdrying of lighter fabrics and their
increased shrinkage or wrinkling.
Cycle tips
• Dry most loads using the preset cycle settings.
• Refer to the Auto Dry or Manual Preset Cycle Settings chart
(in the "Cycles" section) for a guide to drying various loads.
Drying temperature and Auto Dry Level are preset when
you choose an Auto Dry Cycle.You can select a different
dryness level, depending on your load by pressing Auto
Dry Level and tapping More or Less.
if you wish to adjust the cycle length of a Manual Cycle,
press More Time or Less Time. Adjust the temperature of
a Manual Cycle by pressing Temperature until the desired
temperature is selected.
NOTE: You cannot choose an Auto Dry Level with Manual
Cycles.
_ S
Follow the progress of your dryer with the drying Status indicator
lights.
WET•
DAMP•
COOLDOWN•
CLOTHES D RY•
WRINKLE GUARD •
CHECK LINT SCREEN•
CONOTOLLOCKED•
Wet
The Wet light glows at the beginning of Auto Dry or Manual
cycles if a wet item is detected.
• In an Auto Dry Cycle, if a wet item is not detected after 5
minutes, the dryer goes directly into Cool Down and the Cool
Down and WRINKLE GUARD <_ indicators glow, if selected.
• In a Manual Cycle, if a wet item is not detected, the dryer will
continue to run for the length of time selected, but the Wet
light will not glow.
Damp
The Damp light glows in an Auto Dry Cycle when the laundry is
approximately 80% dry. Damp Dry Signal beeps, if selected. (See
"Options.")
Cool Down
The Cool Down light glows during the cool down part of the
cycle. Laundry cools for ease in handling.
Clothes Dry
The Clothes Dry light glows when the drying cycle is finished.
This indicator stays on during WRINKLE GUARD ®
WRINKLE GUARD °
The WRINKLE GUARD ® light glows when this option is selected.
This indicator stays on with Clothes Dry.
Check Lint Screen
The Check Lint Screen light reminds you to check the lint screen.
The light glows when the user selects a cycle. It goes out when
the door is opened, Start is pressed, or until 5 minutes elapses.
Control Locked
The Control Locked light glows when this option is enabled.
Indicator lights
Other indicator lights show Cycle, Options, Modifiers and End of
Cycle settings selected. The display shows the estimated or
actual time remaining.
Select the drying cycle that matches the type of load you are
drying. (See Auto Dry or Manual Preset Cycle Settings charts.)
AUTO DRY DELICATE ULTRADEUCA'_ MANUAL
CYCLES __I CYCLES
MED DRY
CASUAL
_i.o_ EXPRESSDRY
NORMAL_/
TOUCH UP
JEANS
HEAVY DUW
Auto Dry Cycles allow you to match the cycle to the load you are
drying. See the following "Auto Dry Preset Cycle Settings" chart.
Each cycle dries certain fabrics at the recommended
temperature. A sensor detects the moisture in the load and
automatically adjusts the drying time for optimal drying.
Heavy Duty
Use this cycle to get high heat for hea W fabrics such as cotton
towels or bedspreads.
Jeans
Use this cycle to get medium-high heat for drying denims.
19