Table of Contents
Advertisement
Available languages
Available languages
3.
Place wet items on top of the rack. Allow space around items
for air to circulate. The rack does not move, but the drum will
rotate. Make sure items do not hang over the edges or
between rack grille.
4. Close the door.
5. Select TIMED DRY and MORE TIME or LESS TIME. Reset
time as needed to complete drying. Refer to the following
table.
6. Select the desired temperature
setting to match the fabrics in
your load by pressing TEMPERATURE. Items containing
foam, rubber, or plastic must be dried on a clothesline or by
using the Air Dry temperature
setting. Refer to the following
table.
7. Start the dryer.
To remove the dryer rack, lift it straight up and out of the dryen
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the rack.
Suggested
Items for Rack
Temperature
Suggested
Drying
Setting
Time*
(Minutes)
Washable wool items (block to
Low
20
shape and lay flat on rack)
Stuffed toys (cotton or
Low
20
polyester fiber filling)
Stuffed toys (foam rubber
Air Dry
50
filled)
Galoshes (rubber)
Air Dry
20
Foam rubber pillows
Air Dry
50
Tennis shoes
Air Dry
20
* Reset time as needed to complete drying.
DRYER CARE
Keep dryer area clear and free from items that would obstruct the
flow of combustion
and ventilation air
Explosion Hazard
Keep flammable
materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
Failure to do so can result in death, explosion,
or fire.
Every load cleaning
The lint screen is located in the door opening of the dryer. Clean it
before or after each load. A screen blocked by lint can increase
drying time.
To clean
1. Pull the lint screen straight up. Roll lint off the screen with
your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
2.
Push the lint screen firmly back into place.
IMPORTANT:
•
Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
Some towels made of synthetic fibers and natural fibers
(polyester and cotton blends) may shed more lint than other
towels, causing your dryer's lint screen to fill up faster. Be
sure to remove lint from the lint screen before and after drying
new towels.
•
If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. (See "Venting
Requirements.")
Page 22
Hide quick links:
Advertisement
Chapters
Table of Contents
