Code 93
6 Code 93
Enable/Disable Code 93
Parameter # 09h
Enable/Disable Code 93
To enable or disable Code 93, scan the appropriate bar code below.
Parameter # 09h
To enable or disable Code 93, scan the appropriate bar code below.
Set Lengths for Code 93
Parameter # L1 = 1Ah L2 = 1Bh
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s) the code
contains. Lengths for Code 93 may be set for any length, one or two discrete lengths, or lengths within a specific range. To
set lengths via serial commands, see
One Discrete Length - Select this option to decode only those codes containing a selected length. For example, select
Code 93 One Discrete Length, then scan 1, 4, to limit the decoding to only Code 93 symbols containing 14 characters.
Numeric bar codes begin on
34
Enable Code 93
*Disable Code 93
Setting Code Lengths Via Serial Commands on page
page
4-73. To change the selection or cancel an incorrect entry, scan
Code 93 - One Discrete Length
(01h)
(00h)
A-7.
Cancel on page
4-74.
Barcode scanner configuration guide