Code 39; Enable/Disable Code 39; Enable/Disable Trioptic Code 39 - Philips Pocket Memo DPM8500 Configuration Manual

Code 39

Code 39
5 Code 39

Enable/Disable Code 39

Enable/Disable Code 39
Parameter # 00h
Enable/Disable Code 39
Parameter # 00h
To enable or disable Code 39, scan the appropriate bar code below.
Parameter # 00h
To enable or disable Code 39, scan the appropriate bar code below.
To enable or disable Code 39, scan the appropriate bar code below.

Enable/Disable Trioptic Code 39

Enable/Disable Trioptic Code 39
Parameter # 0Dh
Enable/Disable Trioptic Code 39
Parameter # 0Dh
Parameter # 0Dh
Trioptic Code 39 is a variant of Code 39 used in marking computer tape cartridges. Trioptic Code 39 symbols always
Trioptic Code 39 is a variant of Code 39 used in marking computer tape cartridges. Trioptic Code 39 symbols always contain six characters.
contain six characters.
Trioptic Code 39 is a variant of Code 39 used in marking computer tape cartridges. Trioptic Code 39 symbols always
contain six characters.
To enable or disable Trioptic Code 39, scan the appropriate bar code below.
To enable or disable Trioptic Code 39, scan the appropriate bar code below.
To enable or disable Trioptic Code 39, scan the appropriate bar code below.
Trioptic Code 39 and Code 39 Full ASCII cannot be enabled simultaneously. If the Enable Trioptic Code
NOTE
NOTE: Trioptic Code 39 and Code 39 Full ASCII cannot be enabled simultaneously. If the Enable Trioptic Code 39 setting is not accepted*, disable
39 setting is not accepted*, disable Code 39 Full ASCII and try again.
Trioptic Code 39 and Code 39 Full ASCII cannot be enabled simultaneously. If the Enable Trioptic Code
Code 39 Full ASCII and try again. NOTE
39 setting is not accepted*, disable Code 39 Full ASCII and try again.
* An SSI parameter entry error, event ID 07h, is sent to the host if packeted data communication is
* An SSI parameter entry error, event ID 07h, is sent to the host if packeted data communication is enabled to inform the user that the parameter
enabled to inform the user that the parameter change was not accepted.
* An SSI parameter entry error, event ID 07h, is sent to the host if packeted data communication is
change was not accepted.
enabled to inform the user that the parameter change was not accepted.
Barcode scanner configuration guide
*Enable Code 39
(01h)
*Enable Code 39
(01h)
Disable Code 39
(00h)
Disable Code 39
(00h)
Enable Trioptic Code 39
(01h)
Enable Trioptic Code 39
(01h)
*
Disable Trioptic Code 39
(00h)
*
Disable Trioptic Code 39
(00h)
29