Set Lengths For Code 11 - Philips Pocket Memo DPM8500 Configuration Manual

Set Lengths for Code 11

Parameter # L1 = 1Ch L2 = 1Dh
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s) the code contains. Set lengths for
Code 11 to any length, one or two discrete lengths, or lengths within a specific range.
• One Discrete Length - Select this option to decode only Code 11 symbols containing a selected length. Select the length using the numeric bar
codes beginning on page 56. For example, to decode only Code 11 symbols with 14 characters, scan Code 11 - One Discrete Length, then scan 1
followed by 4. To correct an error or to change the selection, scan Cancel on page 57.
• Two Discrete Lengths - Select this option to decode only Code 11 symbols containing either of two selected lengths. Select lengths using the
numeric bar codes beginning on page 56. For example, to decode only those Code 11 symbols containing either 2 or 14 characters, select Code
11 - Two Discrete Lengths, then scan 0, 2, 1, and then 4. To correct an error or to change the selection, scan Cancel on page 57.
4 - 44 SE655 Decoded Linear Imaging Engine
• Length Within Range - Select this option to decode a Code 11 symbol with a specific length range. Select lengths using numeric bar codes beginning
on page 56. For example, to decode Code 11 symbols containing between 4 and 12 characters, first scan Code 11 - Length Within Range. Then
scan 0, 4, 1, and 2 (single digit numbers must always be preceded by a leading zero). To correct an error or change the selection, scan Cancel on
Set Lengths for Code 11 (continued)
page 57.
• Any Length - Scan this option to decode Code 11 symbols containing any number of characters within the scan engine capability.
Barcode scanner configuration guide
Code 11 - One Discrete Length
Code 11 - Two Discrete Lengths
Code 11 - Length Within Range
Code 11 - Any Length
37